HL-20210202
Hydraloop Installation Manual
8
6.
Installation
The installation and commissioning of the Hydraloop unit can only be carried out by approved installers who
have been trained by Hydraloop Systems B.V. This chapter will provide both basic and detailed information
for the most important installation steps. The image below shows an overview of the installation principle.
See next chapters for more details to each subject. (use this image for reference).
-
Use
shower & bath
water as source water and optionally laundry machine water in case a Hydraloop
laundry machine recycle option is installed.
No washbasins, kitchen sinks & dishwasher may be
connected!
-
Use
shower & bath
water as source water and optionally laundry machine water in case a Hydraloop
laundry machine recycle option is installed.
No washbasins, kitchen sinks & dishwasher may be
connected!
-
Connect all separated greywater pipes from shower and bathtubs via a single 2” pipe to the 1.5”
inlet on the top of the Hydraloop unit (if necessary via a lift pump).
-
Hydraloop has a built-in overflow facility, no additional connection to the sewer is required
-
The 50mm|2" greywater feed tube from the shower/bath
MUST
vent to open air in accordance with
local plumbing code through a vent stack to support shower water flowing without airlocks to the
Hydraloop unit and to ensure proper functioning of the Hydraloop unit.
-
With the laundry machine recycle option installed, the wastewater tube from the laundry machine
needs to be fed into the inlet of the Hydraloop system via a sanitary lift pump with a built-in
overflow. The power cord of the sanitary lift pump should be connected to the Hydraloop system so
the lift pump can be controlled by the Hydraloop unit