HL-20210202
Hydraloop Installation Manual
11
6.5 Hydraloop greywater inlet installation
Place the Hydraloop supply pipe and incoming water sensor as following:
1.
First place the blue sealing ring in the top lid in feed channel.
2.
Install the in-feed tube system into the sealing ring with a minimal
amount of grease (Vaseline) applied on the Y-tube end.
3.
Connect the air release tube in the push-in fitting of the branch of
the Y-tube.
4.
Connect the solid blue pressure sensor near the 45
°
bend.
5.
Connect the transparent pressure sensor near the 90° bend.
6.6 Using a lift pump
If the Hydraloop unit is on the same or higher floor as the shower/bath or laundry machine an appropriate lift
pump has to be installed to pump the greywater from the source up into the Hydraloop system.
If a Hydraloop unit is equipped with the laundry machine water recycle option, the ideal place for installation
would be close to the laundry machine, so that the laundry machine lift pump can be placed next or close to
the laundry machine itself. If the laundry machine is placed on the same floor as the Hydraloop but in
another room, the laundry machine lift pump can be installed close to the laundry machine itself and the
greywater is lifted up, and from there flows by gravity to the Hydraloop unit water inlet. The laundry machine
lift pump is controlled by the Hydraloop unit. The laundry machine lift pump power cord should be
connected to the Hydraloop. For more information check the installation manual of the applied lift pump.