HL-20210202
Hydraloop Installation Manual
14
7.
Commissioning & Initial startup of the Hydraloop unit
The commissioning should be performed by an accredited Hydraloop Partner that is trained to commission
the Hydraloop unit.
Commissioning steps:
1.
Open external back up water source (tap or rainwater). Be sure the water pipe is rinsed before
connecting to the Hydraloop unit so there is no dirt entering the float valve and Hydraloop unit,
because this could damage the float valve, electric valves and the water pump.
-
The small water tank on the lower left side should fill with water and the float valve should close
when the maximum water level in the tank is reached.
2.
Switch Hydraloop power switch on
-
This start up procedure takes about 2 minutes.
-
After this, please flush each toilet after each other in the building once, to push air out of the
pipes.
-
The Hydraloop unit will now only supply backup water to the house because at this stage the
Hydraloop unit is not yet activated for recycling. The LED light on the front plate will be green.
You can now check all connections to and from the Hydraloop unit for leaks.
3.
WiFi setup: After the Hydraloop unit is switched on, it will automatically create a WiFi network
showing a number (looks like 00:AB:00:AB:11)
-
elect this Hydraloop WiFi network, that shows the long number, on your smart phone, tablet or
computer (device) and enter the password: PASSWORD
-
Check if your device is connected to the Hydraloop WiFi network (with the long number).
-
Open an internet browser on your device and enter the
URL 192.168.4.1. A page will open.
-
Enter the existing WiFi network of the house/building
that you want the Hydraloop unit to connect with, and
enter the password belonging to this WiFi network on the
page that is displayed and press ‘Submit’. The Hydraloop
unit will now connect with this local WiFi network. Note:
Spaces, commas, capitals etc. all should be entered
correctly.
Note: If the WiFi network does not have a password leave this
field blank.
4.
Enter/scan Hydraloop ID with Hydraloop App:
-
Download and open the Hydraloop app on a smartphone (IOS or Android). Go to ‘settings,
installation, enter/scan Hydraloop ID’.
-
Enter the serial number of the Hydraloop unit that is printed on the Hydraloop Data Plate that is
attached on the right hand top of the Hydraloop unit,
-
or press ‘scan barcode’ and scan the bar code that is visible on the same Hydraloop Data Plate
that is attached on the right hand top of the Hydraloop unit.
-
After the information is entered correctly the central server at Hydraloop Systems B.V. will
connect to this specific Hydraloop unit and will perform a brief system check.
5.
Installers Initial Setup: For the initial setup the installer needs to press ‘Setup Hydraloop’ and enter
the ‘installers code’. This will give access to the ‘setup’ section of the App.
-
(if you do not have the installers code please contact Hydraloop Systems B.V.)