HYDAC FILTER SYSTEMS GMBH
Operation | 6
BeWa OF5 CM 3580053c en-us print
57 / 80
6.2.3 Filtration up to the required cleanliness class
For filtration up to the required cleanliness class operating
mode, proceed as follows:
Fig. 19:
Filtration to the cleanliness class operating mode
For filtration up to the required cleanliness class, proceed as
follows.
ü
The setting of the limit value of the target cleanliness in
the ContaminationSensor has no effect on the operation
of the filter unit. An automatic switch off of the filter unit
after the limit value of the target cleanliness has been
reached, is not active.
1.
Select the right filter element for an operating mode and
exchange this according to the chapter Changing the fil-
ter element.
2.
Connect the suction hose to the oil tank/container and fit
the suction hose in it and also secure it against falling
out.
3.
Connect the pressure hose to the oil tank/container and
fit the pressure hose in it and also secure it against fall-
ing out.
4.
Connect the filter unit to the voltage source.
1
2
3
4
5
6
7
8
9
