Switching on the FCU
Switching on the FCU
When the FCU is switched on, various things are shown in the display, i.e.
model no., firmware version, available memory, battery charge status, bus
address and, possibly, error messages (cf. Error Messages / Troubleshooting
chapter).
Example:
1. HYDAC FILTER SYSTEMS
FCU 2210 V3.22
2. Memory: 25.4% 61
Battery: 13.49 V 80%
3. Bus address: 1
Battery: 13.49 V 80%
4. Viscosity range:
1-10 mm²/s
5. Measure -> OK/START
Abort -> STOP
The FCU is now ready for operation.
Selecting the Viscosity Range
During startup, the viscosity range currently set is shown in the display.
Before the first measurement, check the viscosity of the fluid to be measured
and correct the settings if required. You can find details on change-over of
the viscosity range on page 78.
The FCU provides two viscosity ranges for selection:
1 … 10 mm²/s
5 … 1000 mm²/s
FCU 2000-4 series
en(us)
41 / 120
BEWA FCU2000-4 3109987h en-us 2017-01-24.docx
2017-01-24
