HYDAC FILTER SYSTEMS CSM-E, Installation And Maintenance Instructions Manual

Page: 35 / 64

Adjusting the counter balance valve
Setting the counter balance valve with a pressure gauge
To set up the counter balance valve with a pressure gauge, an additional
pressure gauge 0-40 bar with a screw connection and a gauge port screw
connection is required.
Pressure gauge 0-60 bar, including gauge port screw connection
A matching pressure gauge kit is available as an accessory, see
"Accessories" chapter.
To set the counter balance valve, proceed as follows:
1. Loosen the screw plug on the
right-hand side of the CS in a
counterclockwise direction and
remove it completely.
2. Screw the gauge port connector
(A) into the CS.
CSM-E en(us) Page 35 / 64
MoWa CSM-E 3911629a en-us 2017-12-11.docx 2017-12-11