Poseidon 4002
– Manual
HW group
www.HW-group.com
First steps
Configure network parameters
IP address / HTTP port (80 by default)
Network mask
Gateway IP address for your network
Device name (optional)
Click the
Apply Changes
button to save the
settings.
You may also use the following utilities to configure the IP address:
UDP Config for Linux
RS-232 serial port
(any terminal program, 9600 8N1, DIP1=ON, restart)
IMPORTANT:
To reset the device to factory defaults, toggle DIP1 several times within 5 seconds after
power-up.
No configuration changes can be stored while DIP2=On. To change the IP address, set
DIP2=Off.
