Poseidon 4002
– Manual
HW group
www.HW-group.com
Outputs
Output mode:
A)
Manual
Output can be controlled in the Flash interface, or from any application using M2M protocols
(XML, SNMP, Modbus/TCP).
The output
cannot be used in “thermostat” mode – See local condition.
B)
Local Condition
The output cannot be controlled in the Flash interface. The output is controlled with a
specified condition. The output is read-only for all M2M protocols.
The output cannot be controlled remotely.
o
On if any alarm
The output is active if at least one of the inputs or sensors is in alarm.
o
On if value equal to Trigger
The output is active if the sensor reading matches the “Target Value”.
o
On if value higher than Trigger
The output is active if the sensor reading exceeds the “Target Value”.
o
On if value lower than Trigger
The output is active if the sensor reading is below the “Target Value”.
o
Dependent On
–
sensor / input to which the condition applies.
Warning:
Configuration changes must be confirmed by clicking the Apply Changes button.
Choose output mode
Manual
mode:
Output controlled over the
WEB or M2M protocols
Local Condition
mode:
Output activated by the
“Htemp Rack 19” sensor if
the temp exceeds 30°C
