Husqvarna HUV4420, Service Manual

Page: 33 / 74

BODY AND TRIM Seat
2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual Page 4-7
4
ý
WARNING
• Ensure that the ROPS is properly installed before operating the vehicle.
SEAT
See General Warning, Section 1, Page 1-1.
SEAT REMOVAL
1. Lift the seat back up and forward to raise it.
2. Remove the seat by lifting the front edge hinges from the vehicle frame hinge slots.
SEAT ADJUSTMENT
1. Passenger Seat
1.1. Remove the seat from the vehicle.
1.2. Remove the four bolts and washers from the bottom of the seat mounting plate.
1.3. Align the mounting plate holes with the holes in the seat to achieve the desired seat position.
1.4. Install the washers and bolts, and tighten the hardware to 96 in-lb (10.8 N·m).
1.5. Install the seat. See following WARNING.
ý
WARNING
• Ensure that the seat hinges and latch are securely engaged before operating vehicle.
2. Driver Seat
2.1. Sit in seat, grasp seat adjustment handle under seat bottom and slide seat to desired position. See
preceding WARNING.
SEAT INSTALLATION
1. Align the hinges on the underside of the seat front edge with the hinge slots on the frame.
2. Push back and down on the seat back to secure the seat latch to the frame. See preceding WARNING.
SEAT FRAME REMOVAL
1. Remove the bolts, washers, and flanged locknuts from the seat frame (7), seat side plates, and engine
cover plate (Figure 4-4, Page 4-6) .
2. Remove the seat frame.
SEAT FRAME INSTALLATION
1. Install the seat frame (7) (Figure 4-4, Page 4-6) .
2. Secure the seat frame to the seat side plates with bolts, washers, and flanged locknuts. Tighten the hard-
ware to 37 ft-lb (50 N·m).