36 –
English
MAINTENANCE AND SERVICE
Protection covers
•
Make sure all protection covers are in place and in good
condition.
For more information, see the ”Machine’s safety equipment”
section.
Drain cooling water from gearbox to prevent rust
and/or freeze damage.
•
To drain water from gearbox, turn the drain tap
counterclockwise to open and clockwise to close.
Check the water spray over the diamond blade.
Raise blade guard front and use spring hook to lock it in
upright position.
•
Open the Water valve on the control panel. Make sure it is
straight jets of water out of the holes from the water pipes
on both sides of the blade and no leakage. Replace water
pipe if damaged.
Drain fuel filter water separator from water
•
Drain the fuel filter water separator by using the hose in
the bottom. Put the hose in a bottle or a can, loosen the
drain tap and drain any water collected inside the
separator.
After the first 50 hours
Replace engine oil and filter
•
Remove the top cap from the hose. Open the valve and
bend it down to empty the system.
Remove the filter and replace it.
Fill the new filter with oil and lubricate the seal with a few
drops of oil prior to refitting it.
•
Refill the system at either of 2 locations on the engine.
NOTICE! Treat this water as fuel and dispose properly.
NOTICE! Protect the battery from oil spill prior to removing
and refitting.
1
2
Summary of Contents for FS7000 DL
Page 159: ......
