Husqvarna CRT48-33K, Operator'S Manual

Page: 93 / 108

Warn Personnel Before Starting
Before starting, walk completely around the machine.
Make sure no one is on it or close to it . Let others
know you are starting up and don’t start until everyone
is completely clear of the machine. As the equipment
operator, you are responsible for the safe use of the
machine, so always make sure you have communicated
your work plans to others on the site.
Check the trowel thoroughly at delivery for any shipping
damage.
Locate the trowel in an accessible location, as close to
the work site as possible.
Secure the trowel after it is placed in its intended
operating position so it does not tip, roll, slide or fall.
Starting the Engine
WARNING! Never attempt to start the engine by
shorting across starter terminals. Serious injury or
death may result.
Know the exact starting procedure for your machine.
See the manufacturer’s operating manual(s) for starting.
• Familiarize yourself with warning devices, gauges and
operating controls.
• Make sure controls are in the neutral/locked position.
• Clear the area of all persons.
• Start the engine following the instructions in the
manufacturer’s operating manual(s).
• If necessary to run the engine or operate the machine in
an enclosed area, ensure there is adequate ventilation.
WARNING! Never operate the machine without
adequate ventilation. Exhaust fumes can kill. Do not
breathe exhaust fumes!
For a walk-behind (pedestrian operated) trowel machine,
make sure that a circular area with a minimum radius
equal to the length of the machine is clear. This will
ensure safety of personnel around the machine.
Before starting,
walk completely
around trowel
Start Safely
17
Starting Aids
If you have trouble starting the engine and need to use
jumper cables, follow the instructions in manufacturer’s
operating manual(s).
Jump-starting is a two-person
operation. The operator must be in the operator’s seat
when jump-starting so the machine will be under control
when the engine starts.
WARNING! Improper jump-starting procedures may
cause serious injury or death from a battery explosion or
a run-away machine.
Always use proper jump-starting
procedure. (See page 29, Battery Hazards .)
Ether/cold start fluid is HIGHLY FLAMMABLE. Before
using it, always read the instructions on the ether/
cold start fluid container and the instructions in the
manufacturer’s operating manual(s).
WARNING! Avoid injury from explosion or fire. If the
engine is equipped with a glow plug pre-heater or other
intake manifold type pre-heater, follow manufacturer’s
instructions before using ether/cold start fluid.
After Starting Engine
Observe gauges, instruments, and warning lights to
assure that they are functioning and their readings are
within the operating range.
Run an Operating Check
Do not use a machine that is not in proper operating
condition. It is your responsibility to check the condition
of all systems and to run the check in a safe area.
To avoid explosion,
follow proper jump-
starting procedures
Never start engine
by shorting across
starter terminals
Start Safely
18