Husqvarna CRT48-33K, Operator'S Manual

Page: 39 / 108

wc_tx002045gb.fm
39
CRT 48-33K Operation
4.9 Installing the Liquid Propane (LP) Cylinder
Introduction A LP cylinder is not provided with this machine. It is the owner’s responsibility to
purchase and install LP cylinders. See topic
Recommended Fuel (LP) for the
appropriate size and specifications.
Requirements

Engine stopped

Fuel change switch in LPG position

Full LP cylinder

Personal Protective Equipment (gloves and eye protection)
Procedure Perform the procedure below to install the LP cylinder.
1. Locate the discharge valve (a) on the LP cylinder. Rotate the knob clockwise to
make sure that the discharge valve is fully closed.
2. Lift the LP cylinder and place it on the tank mount (b) . Orient the cylinder as
shown. Snap the clamps (c) to hold the cylinder in place.
3. The gas supply hose on the machine is equipped with a female coupling (d) .
Thread the female coupling onto the male coupling (e) on the discharge valve.
Tighten the female coupling securely by hand until the hose connection is tight.
This procedure continues on the next page.
WARNING
Fire, asphyxiation, chemical burn, and explosion hazards. Liquid propane (LP)
presents special hazards during operation and fueling. Failure to follow the
warnings and safety standards could result in serious injury or death.
 Read and follow all instructions and safety information regarding LP usage pre-
sented in this Operator’s Manual
wc_gr009986
a
c
b
e
d