Husqvarna CRT48-33K, Operator'S Manual

Page: 43 / 108

wc_tx002045gb.fm
43
CRT 48-33K Operation
4.12 Before Starting
Requirement Operator must be familiar with the location and function of all controls.
Checklist Check the following items before starting the trowel:
 fuel level—add fuel as needed
 oil level in the engine—add oil as needed
 air filter—element is clean and undamaged
 trowel arms and blades—functional and undamaged
 wiring and electrical connections—check every 50 hours
4.13 Starting the Machine
Requirements

Fuel change switch in the correct position (LPG or gasoline)

Choke closed (only if running the engine on gasoline)
Note: Do not use the choke if running the engine on LPG.
Procedure Perform the procedure below to start the machine.
1. Sit in the operator’s seat.
2. Turn the engine key switch (o) clockwise and hold it until the engine starts.
3. Allow the engine to idle for 5 minutes.
You may now begin operating the trowel.
NOTICE: Cranking the engine for more than five seconds can cause starter
damage.

If the engine fails to start, release the key switch and wait 10 seconds before
operating the starter again.

If the engine still will not start after multiple attempts, see Troubleshooting .
wc_gr010113
o