![background image](http://html.mh-extra.com/html/husqvarna/326c-326l-326lx-series-326ldx-series/326c-326l-326lx-series-326ldx-series_workshop-manual_170661049.webp)
48
7
Crankshaft and crankcase
502 54 11-02
Check that the guide rail and its
gaskets are undamaged.
A rail sits in the bottom of the
crankcase and has the task of guiding
the fuel-air mixture up towards and into
the cylinder.
Check that the gasket (A) which lies
around the rail is undamaged and the
gaskets (B) that are to seal against the
cylinder.
Place the crankshaft in position in the
crankcase and assemble the remaining
parts in the reverse order as set out for
dismantling.
Lubricate the big-end bearing with a
few drops of engine oil and position the
crankshaft in the crankcase.
Assemble all the remaining parts in the
reverse order as set out for
dismantling.
See respective sections if necessary in
the Workshop Manual.
Leakage testing the
crankcase
Fit the two sealing plates (A).
Leakage testing the
crankcase
Remove the cylinder cover, spark plug
and grille over the muffler
Loosen the screws holding the
carburettor sufficiently so that the
sealing plate no. 502 54 11-02 (A) can
be slid down between the carburettor
and partition.
It may be necessary to carefully pry
out the carburettor sufficiently using a
screwdriver.
Place a plate (A) between the cylinder
and heat guard by the muffler.
NOTE!
Press down the sealing plates as
far as possible between the bolts
to ensure a proper seal.
Summary of Contents for 326C, 326L, 326LX-Series, 326LDX-Series
