Husqvarna 326C, 326L, 326LX-Series, 326LDX-Series, Workshop Manual

Page: 13 / 55

12
2
Electrical system
502 51 34-02
502 54 15-01
502 51 49-01
Fit the piston stop no. 502 54 15-01
and remove the nut holding the
flywheel. Fit piston stop no. 502 54 15-01 in the
spark plug hole.
Remove the nut holding the flywheel.
NOTE!
Position the piston stop so it is clamped between the piston crown and the
combustion chamber. Not so it sticks out into the exhaust port.
Remove the flywheel. Dismantle the flywheel from the
crankcase using the puller
no. 502 51 49-01.
Gently knock the puller screw with a
hammer, if the flywheel sits tightly on
the crankshaft.
Assembly
Check that the cast key in the flywheel
and key way in the crankshaft are
undamaged.
Fit the flywheel and centrifugal clutch.
Do not forget the washers (A).
Note the slots on the washer lie closest
to the flywheel. Align with the
equivalent pins on the flywheel.
Assemble the ignition module and
adjust the air gap to 0.3 mm. Assemble the ignition module.
Adjust the air gap. It should be 0.3 mm
between the permanent magnets in the
flywheel and the ignition module.
Assemble other parts in the reverse
order as set out for dismantling.
NOTE!
Do not forget the rubber bushings between the fuel tank and the clutch
cover and the starter.