Husqvarna 326C, 326L, 326LX-Series, 326LDX-Series, Workshop Manual

Page: 22 / 55

21
3
Fuel system
• Mount the valves and dampers.
Tip!
Any numbers on the valves should be
able to be read from the outside.
Replace the fuel screen if it is damaged
or cannot be cleaned.
Place the pump diaphragm closest to
the carburettor housing. Then the
gasket and cover and the other
components in reverse order of
removal.
NOTE!
Check that the valves are turned
correctly and that they close
completely and tightly in the
closed position.
Use Loctite on the valve screws.
Attach the various parts of the
measuring unit in the reverse order as
set out for dismantling.
The lever arm should lie flush with the
carburettor housing.
Attach the various parts of the
measuring unit in the reverse order as
set out for dismantling.
The lever arm should lie flush with the
carburettor housing.
Too high setting = too much fuel.
Too low setting = too little fuel.
NOTE!
The H-needle is a little shorter
than the L-needle.