Husqvarna 326C, 326L, 326LX-Series, 326LDX-Series, Workshop Manual

Page: 6 / 55

5
1
Starter
Assemble the starter handle. Assemble the starter handle.
Tie a double knot and fold under the
free end.
Pull the knot fully into the handle.
Tension the return spring.
Check the spring tension.
Fit the starter on the engine body.
Do not forget the guide sleeves for the
fuel tank.
Tension the return spring. Pull out the
starter cord fully and lift it out of the cut-
out in the starter pulley.
Now turn the starter pulley anticlock-
wise, 6 turns.
Check the spring tension. With the
starter cord fully extended it should still
be possible to turn the starter pulley
further,
at least a half turn.
Fit the starter on the engine body.
First press in the top edge of the starter
under the cylinder cover.
Fit the starter on the engine body.
1. Check that the rubber bushings are
in position in the starter housing.
2. Insert the top edge of the starter
under the cylinder cover and fold
the starter in against the engine
body.
Press in the starter against the engine
body and check that the drive dog
engages.
Fit the screws.
3. Check that rubber bushings in the
starter housing connect against the
lips on the fuel tank.
4. Press the starter in against the
engine body.
5. Pull the starter handle and check
that the drive dog engages.
6. Tighten the screw in the centre of
the starter first followed by the 2
other screws.