Husqvarna 326C, 326L, 326LX-Series, 326LDX-Series, Workshop Manual

Page: 34 / 55

33
5
Angle gear
503 97 64-01
D
B
C
A
NOTE!
Do not forget to fill the gear
housing to approx. 3/4 with gear
housing grease 503 97 64-01 once
the plug (D) has been removed.
Assembly
Clean all component parts and replace
if damaged or worn.
Fit the bearings on respective axles.
This is easier if the bearings are
heated to approx. 110°C using a hot air
gun.
The bearings on the input axle are
sealed on one side. Turn the bearings
so this side faces outwards.
Heat the gearbox to approx. 110°C and
first place the output axle in position
and then the input axle.
Make sure the bearing bottoms in its
seating.
Fit the circlips (B) and (C). Make sure
they lie correctly in their grooves.
Assemble remaining parts in the
reverse order as set out for dismantling.
NOTE!
Do not forget the circlip (A)
holding the bearing on the input
axle.
Dismantle the bearings from the output
and input axles.
Dismantle the bearings from the output
and input axles with the help of a small
bearing puller.
TIP!
Hold the bearing puller in a vice so that
it gains a better grip around the
bearing.