STEP THREE OF WEBBING PROCEDURE: ________________________________________________________
----- Establish Path of Pressure-sensitive Over-laminate
•
Load the roll of pressure-sensitive over-laminate
onto the rear roll easel shaft with the roll feeding
off the bottom of the roll easel shaft.
•
Align and adjust the roll of pressure-sensitive
over-laminate to the roll of Marking film.
•
Pull a length of over-laminate forward and
separate the release liner from the over-
laminate.
•
Pass the over-laminate over the back of the top
pull roller and into the nip of the lower pull roller.
•
Pull the over-laminate down over the Marking
film to the lower rear wind-up tube.
•
Tape the release liner securely to the rear top
wind-up tube so that it will be automatically
wound up.
•
At this point, take up the slack of the Marking
film roll on the front lower unwind shaft.