STEP ONE OF WEBBING PROCEDURE DIAGRAM: _________________________________________________
_____
Establish Path of Marking Film
þ
WARNING! Take care reaching over the top main roller since the roller is very hot at the 300
°
F (149
°
C) temperature.
•
Load the roll of Marking film onto the bottom front
unwind shaft, toner-accepting side facing out. Load
the roll with the media feeding off the front of the
unwind shaft.
•
Center the roll on the unwind shaft as explained in
"Setting the Brakes".
•
Place a cardboard core over the bottom rear wind-
up tube for winding up the finished product. Adjust
and align the cardboard core to the roll of marking
film.
•
Raise both the top rollers for ease of webbing.
•
Pull the Marking film forward, behind the tie bar,
and through the nip of the main rollers.
•
Feed the film over the first chill idler and under the
second chill idler.
•
From the back of the laminator, pull the film
through the pull rollers and down to the bottom rear
wind-up tube. Tape the film securely to the
cardboard core and rotate a few inches of film
around to secure.
