8. Turn the pod shaft until the rounded end of the transducer points in the
direction of travel. The centerline of the transducer should be parallel with
the centerline of the boat. See the illustration
Aligning the Transducer.
NOTE:
You might need to loosen the hex socket bolts to adjust the transducer
alignment.
9. When the transducer position is finalized, hand-tighten the hex socket bolts
completely so the pod shaft is fully secure and won’t drop or rotate during
operation.
Hand-tighten only!
10. Above the BowGuard, unscrew the Depth Collar Knob to remove the clamp.
rounded part
of transducer
Aligning the Transducer
Confirming the Pod is Secure
hand tighten
(2) hex socket
bolts 10-32 x 5/8"
pod
shaft
trolling motor
shaft
31
he
he
it
or
AS 360 TM
TM_360_Ultrex_IG_532178-2EN_A.qxp_30895_Eng_531478 2/16/17 5:33 PM Page 31
