Fishing System Defaults to Simulator with a Transducer Attached
In addition to the 360 Imaging accessory transducer, you will have a standard
Humminbird transducer connected to the control head. A connected and functioning
transducer with built-in temperature will cause the newly-started Fishing System to
go into Normal operating mode automatically. If, when you power up the Fishing
System, it goes into Simulator mode automatically, even though a transducer is
already connected, this means that the control head is not detecting the transducer.
Perform the following troubleshooting tasks:
• Check the connections of all transducers that are connected to the control
head or Ethernet network. See the transducer installation guide that was
included with your Fishing System for connection information.
• Review this 360 Imaging installation guide to confirm that the transducer
cable is connected correctly to the Fishing System. Reconnect if necessary,
and power on the Fishing System again to see if this fixes the problem.
• Because the 360 Imaging transducer is on the network, it might take up to a
minute to be detected on the network. Use the 4-WAY Cursor Control key to
select Normal from the Start-Up Options Menu. In this guide, see
Set up the
Control Head, Section 1. Power on and Confirm Connections.
• Replace the non-functioning transducer with a known good transducer if
available and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is damaged
or corroded.
49
wing
ou to
back
uded
nd
nals
Troubleshooting
TM_360_Ultrex_IG_532178-2EN_A.qxp_30895_Eng_531478 2/16/17 5:34 PM Page 49
