Hudson 1955 Rambler, Technical & Service Manual

Page: 162 / 292

16 TECHNICAL SERVICE MANUAL
FIGURE 33— With the Free Wheeling Cam and
Pinion Cage on the Main (Spline) Shaft,
Lock Them in Place With the Pinion
Cage Retaining Clip and the Free
Wheeling Cam Retaining Clip
FIGURE 34—Install a Snap Ring to Hold the
Ring Gear on the Main Shaft
installation of the overdrive main shaft and ring
gear assembly (Fig. 36).
1. Rubber Band
FIGURE 35— A Rubber Band Serves to Hold
the Free Wheeling Rollers in Position
until the Ring Gear and Main Shaft
can be Installed
FIGURE 36— Install the Main Shaft and Ring
Gear on the Pinion Cage and Free
Wheeling Cam
The Speedometer and Governor
Drive Gears
Insert the Woodruff Key into the main shaft.
Then install the governor and speedometer drive
gears. The governor drive gear which is smaller
in diameter, is installed against the shoulder
on the main shaft.
Reinstalling the Main Shaft Bearing
in the Case
Install the bearing inner snap ring in the
overdrive case. Press the bearing in from the
rear of the case until it seats against this