14
Incremental Encoder FG 41
Warranty and liability
In principle the "General Terms and Conditions" of Johannes Hübner - Fabrik elektrischer
Maschinen GmbH apply. These are available to the operator with the Order Confirmation or
when the contract is concluded at the latest. Warranty and liability claims in the case of
personal injury or damage to property are excluded if they result from one or more of the
following causes:
·
Non-observance of these operating and assembly instructions
·
Non-intended use of the measuring system
·
Improper assembly, installation and start-up of the measuring system
·
Work carried out incorrectly on the measuring system
·
Operation of the measuring system with technical defects
·
Mechanical or electrical modifications to the measuring systems undertaken autonomously
·
Repairs carried out autonomously
·
Third party interference and Acts of God
·
Deployment of non-qualified personnel
·
Opening of the measuring system or modifying it
Organizational measures
·
The operating and assembly instructions must always be kept ready-to-hand at the place of
use of the measuring system.
·
In addition to the operating and assembly instructions, generally valid legal and other binding
regulations on accident prevention and environmental protection must be observed and
communicated.
·
The respective applicable national, local and system-specific provisions and requirements
must be observed and communicated.
·
The operator is obliged to inform personnel on special operating features and requirements.
·
Prior to commencing work, personnel working with the measuring system must have read
and understood the
chapter 2 "Basic safety instructions" on page 10
.
·
The nameplate and any prohibition or instruction symbols applied on the measuring system
must always be maintained in a legible state.
·
Do not undertake any mechanical or electrical modifications to the measuring system, except
for those expressly described in this operating and assembly instructions.
·
Repairs may only be undertaken by the manufacturer or a center or person authorized by the
manufacturer.
Personnel selection and qualification; basic obligations
·
All work on the measuring system must only be carried out by qualified personnel.
·
Qualified personnel includes persons, who, through their training, experience and instruction,
as well as their knowledge of the relevant standards, provisions, accident prevention
regulations and operating conditions, have been authorized by the persons responsible for
the system to carry out the required work and are able to recognize and avoid potential
hazards. They are capable of identifying and avoiding potential hazards.
·
The definition of “qualified personnel” also includes an understanding of the standards VDE
0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
·
The responsibility for assembly, installation, commissioning and operation must be clearly
defined. The obligation exists to provide supervision for trainee personnel.
