Hubner C-FLEX, Owner'S Manual

Page: 78 / 82

78 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
WARNING – The system is powered up and voltages are present in the power distribution circuits. Take
care not to make touch any electronics with screws or screw drivers. Always use screw drivers with
isolated handles when working in an opened, powered up system.
5. Remove the steering mirror mount from the position towards the aperture from the laser being aligned
by loosening the mounting bolt and pulling the mirror mount up. The positioning pins can be a tight fit,
some force may be required.
6. Place the mirror mount pin hole in the open position.
7. Use the steering mirror to center the beam on the pin hole horizontally. Maximize the power through
the pin hole. Use the three set screws on the back of the mirror mount to translate the beam
horizontally and make angular adjustments. See Section 10.4 : Angular alignment for a more elaborate
discussion on the steering mirror controls.
8. Use the beam height adjustment to center the beam on the pin hole vertically. Maximize the power
through the pin hole. Loosen the locking screw and rotate the cylinder. Tighten the screw when the
beam height is correct. See Section 10.2 : Vertical alignment for a more elaborate discussion on the
beam height adjustment.