Hubner C-FLEX, Owner'S Manual

Page: 75 / 82

75 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
Angular alignment
Once the beam is aligned horizontally and vertically the same three screws can be used for tip/tilt adjustments,
controlling the beam angle.
When adjusting the beam angle, do not use all three screws. As described above, the dark blue and green screws
are used for angular alignment, turning all three will translate the steering mirror and change the incident
location on the mirror. It may be necessary to iterate between translational and angular adjustment to complete
alignment. The horizontal angle screw can be used to sweep across the aperture to determine the required
horizontal translation direction, then the 3
rd
screw screw is turned in the opposite direction to push the mirror
into positon.