Hubner C-FLEX, Owner'S Manual

Page: 21 / 82

21 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
Connecting the cables from C-FLEX to auxillary equipment
Connecting the controller cables of a Cobolt 04-01 laser
This section describes how to properly connect a controller delivered with a Cobolt 04-01 to the laser head
interface on the C-FLEX. If no Cobolt 04-01 lasers are integrated, proceed to the next section.
NOTICE – Be sure to connect all cables to the laser controllers before supplying power to the
system !
1. For each Cobolt 04-01 laser integrated in the C-FLEX there is a specific controller and cable, they are
labeled with the laser ’s serial number. Separate the controllers and cables by the laser they belong to
and use only the corresponding equipment for each laser.
2. Connect the Controller I/O cable’s 2 -pin molex connector, with black and blue wires, to the laser
controller ’ s key switch socket. Pull gently to be sure the connector is locked in place.
3. Connect the Controller I/O cable’s 6 -pin molex connector, with the black and green wires, to the laser
controller socket labeled ‘Analog’ .
Cobolt 04-01 Controller C-FLEX Back panel