Step 3 (Optional) To enhance the corrosion resistance of a ground terminal, apply silica
gel or paint around the terminal.
----End
Installing the AC Output Power Cable
Step 1 Remove the locking cap from the AC OUTPUT cable gland and then remove the
plug.
Step 2 Route the cable through the cable gland.
NO TICE
1. Select appropriate rubber fittings based on the outer diameter of the AC power
cable to ensure proper sealing.
2. To avoid damaging the rubber fitting, do not route a cable with a crimped OT
terminal directly through the rubber fitting.
3. Adjusting a cable when the thread-lock sealing nut is tightened will shift the
rubber fitting, which will affect the Ingress Protection Rating of the device.
Figure 5-8 Routing a cable
Step 3 Remove an appropriate length of the jacket and insulation layer from the AC
output power cable using a wire stripper.
NO TICE
Ensure that the jacket is in the maintenance compartment.
SUN2000-(60KTL, 65KTL)-M0
User Manual (Mexico Edition)
5 Electrical Connections
Issue 06 (2020-10-12)
Copyright © Huawei Technologies Co., Ltd.
42