![background image](http://html1.mh-extra.com/html/ht/fulltest-3/fulltest-3_user-manual_2178149020.webp)
FULLTEST
3
EN - 19
7 ..... Measurement value (in green colour - result lower than or equal to set limit value, in red colour -
result is higher than set limit value).
8 ..... Real time clock (hh.mm.ss).
9 ..... Unit of measurement result (
).
10 ... Set measurement time (in TIMER mode only).
11 ... Measurement result status (symbol
in green colour - result OK, symbol
in red colour –
result not OK).
5.2.2. CALIBRATION OF TEST LEADS
The calibration is not needed because of 4-wire method.
5.2.3. R
PE-4WIRE
MEASUREMENT
Measured quantities and display ranges:
Continuity R
PE
0
20
Test current
0.2
30 A
1)
Select the R
PE-4WIRE
function by pressing the
FUNC
hard key first.
2)
Check selected limit value and modify it if needed by pressing the
LIMIT
(6) touch-screen key first.
Four independent preset limit values are available in STANDARD limit mode selection for quicker
operations. Select the one closest to wished value and modify it by using the
+
and
―
touch screen
keys if needed.
3)
Check selected mode and modify it if needed by pressing the
MODE
(7) touch-screen key first.
4)
Select measurement screen by pressing the
(4) touch-screen key and check all settings again.
5)
Connect the test leads according to the figure below.
CAUTION
Before connecting test leads to UUT obligatory assure there is no external voltage
higher than 10 V between the test points where test leads will be connected to,
otherwise fuse F4 may blow!
Figure 9: Connection of standard test leads