![background image](http://html1.mh-extra.com/html/ht/fulltest-3/fulltest-3_user-manual_2178149029.webp)
FULLTEST
3
EN - 28
The test will be stopped after releasing the
START
/STOP button (MANUAL or BURN mode) or
after elapsing set test time (RAMP mode).
Test result will currently be displayed in green colour if it is lower than or equal to set limit value.
Final result will be equipped with green
symbol and with beep-beep sound (result OK). If break
through occurred during the test then the test will be stopped and limit test current will be displayed
in red colour equipped with red
symbol and with longer beep sound. See the display outlook
with test result on the figure 13.
9)
Save test result by pressing the
SAVE
hard
button twice, for further instructions see the
“MEMORIZING EXAMPLE” section.
SAFETY INPUT
In order to reach higher level of safety the SAFETY INPUT connector is installed. Safety switch of a
mechanical barrier can be connected there in order to disable DIELECTRIC function in case the safety
switch is opened. For this purpose select SAFETY INPUT enabled mode in the menu as follows:
MENU
hard key
SETUP
touch-screen key
SAFETY
touch-screen key
ENABLED
touch-
screen key.
WARNING LAMP
According to EN 50191 the highest level of safety must be undertaken when working with high voltages
like used in DIELECTRIC test. For this purpose the FULLTEST 3 offers an output to drive the high
voltage warning lamp. Use only the lamps supplied by original supplier of the FULLTEST 3 tester.
CAUTION
Always connect COM terminal to GND if measured UUT is grounded,
otherwise possible capacitive leakage current may flow to ground which may
disturb the measurement!
Measurement time in MANUAL mode is limited to 60 min!
The following specific information can be shown on the display during measurement:
Information displayed
Description
EROR1!
Internal fuse may be blown!
The fuse is not customer replaceable, send the tester into
a service department.