HPE ProLiant DL180, User Manual

Page: 96 / 172

HPE 25/40/100 Gb networking
card (Supported up to max 1
pc) No No No Yes Yes No
HPE PCIe Workload
Accelerator options
(Supported up to max 3 pcs) Yes No No Yes Yes No
Installing an expansion board
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Extend the server from the rack .
• Remove the server from the rack .
6. Remove the access panel .
7. Remove the riser cage .
8. If required, remove the air baffle .
9. Identify and then remove the slot blank from the riser cage.
10. If installing expansion board on a low-profile slot on the secondary riser cage, replace the full-height
bracket with the low-profile bracket. See the expansion board document for model-specific support
bracket information.
11. Install the expansion board.
• Primary riser cage
96 Hardware options installation