HPE ProLiant DL180, User Manual

Page: 108 / 172

Internal USB device option
The server has one internal one USB 3.0 port. You can use this port to install internal USB device, that is
intended to be rarely removed, such as USB flash media devices for booting up from flash solutions or for
data backup/redundancy.
Installing an internal USB device
Procedure
1. If installed, remove the front bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Extend the server from the rack .
• Remove the server from the rack .
6. Remove the access panel .
7. Locate the internal USB connector .
8. Plug in the USB device into the internal USB port.
9. Install the access panel .
10. Install the server into the rack .
11. Connect all peripheral cables to the server.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
108 Hardware options installation