HP Surestore 80ex - Optical Jukebox, User Manual

Page: 43 / 96

Chapter 3 3-11
Operating the Jukebox
Using the Front Panel Features
Op
eratin
g th
e
Ju
kebo
x
9. Press
NEXT
until the third number of your current security code displays.
10. Press
ENTER
.
If you entered an incorrect code,
NO CONFIG
displays briefly and then
CONF
17 displays. Repeat steps 4-10 again and enter the correct current code.
After entering the current security code in the previous steps, you are prompted
to enter a new three-digit security code.
11. Press
ENTER
.
NEW 1
and a flashing
0
displays.
12. Press
NEXT
until the first number you want in your security code displays
13. Press
ENTER
.
NEW 2
and a flashing
0
displays.
14. Press
NEXT
until the second number you want in your security code displays.
15. Press
ENTER
.
NEW 3
and a flashing
0
displays.
16. Press
NEXT
until the third number you want in your security code displays.
17. Press
ENTER
.
SET 17
displays briefly.
18. Press
CANCEL
to return to
READY
.
CAUTION
The next step is to turn off the jukebox.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. Check your host system manuals for
information about checking the SCSI bus status. If your computer is connected to a
LAN, be sure to check with your system administrator before turning off power to
the jukebox.
19. Turn the jukebox OFF, then ON to save the code to the jukebox flash ROM.
NOTE You can limit access to your jukebox by setting certain security options. See Table
3-1 for information about configurations 15, 20 and 31.
Customizing the Operation of the Jukebox
You can customize the way the jukebox operates by setting values in its
“configurations.”. See Table 3-1 for a list of these configurations, their default
settings, and possible settings.
NOTE Your security code is required to change configurations 15, 17, 20, and 31.