1. SAS connector
3. Power on/off switch
2. Power connector
Figure 29 Connecting the cables to the tape drive
WARNING!
The supplied power cord is HP approved for your speci
fi
c geographic region. Use of a
non-HP approved power cord may result in: 1) not meeting individual country speci
fi
c
safety requirements; 2) insuf
fi
cient conductor ampacity that could result in overheating
with potential personal injury and/or property damage; and 3) an unapproved power
cord could fracture resulting in the internal contacts being exposed, which potentially
could subject the user to a shock hazard. HP disclaims all liability in the event a non-HP
approved power cord is used.
Reboot the server
Switch on the tape drive and power up the server. The power on/off switch is on the front panel.
Watch the boot screen carefully after installation. If there are any error or unexpected messages go back
and check the SAS cabling carefully.
If this does not resolve the problem, refer to “
Troubleshooting
” on page 73 for further guidelines.
Ultrium half-height SAS Tape Drives
51
Summary of Contents for StorageWorks Ultrium 448
