There is no need to press the Eject button. Just power on your server and press the [F8] function key
during the Power On Self Test (POST). This invokes OBDR to restore your system. For more information
and speci
fi
c instructions please refer to our World Wide Web site at
http://www.hp.com/go/obdr
.
3.
Follow the on-screen instructions to set up the operating system. Normally, you can accept the default
response to all the prompts, for example just press <Enter>.
4.
The LEDs will
fl
ash in OBDR mode (as described in step 2) while the tape drive restores your
operating system to a state where it can run a normal data restore.
5.
Once the operating system has been set up and rebooted, the Ready LED display on the tape drive
changes to constant green and you can remove the backup cartridge, if you wish. You are now
ready to run a normal data restore. Follow the normal process for your restore application.
If restore fails
If the restore fails for any reason, refer to our World Wide Web site (
http://www.hp.com/go/obdr
) and
do a search on “OBDR” for detailed troubleshooting information.
Ultrium half-height SAS Tape Drives
67
Summary of Contents for StorageWorks Ultrium 448
