Installation
17
Network Storage Router M2402 User Guide
Note:
The installation process requires a #2 Phillips and a #2 flat-head screwdriver.
To install the router in the rack:
1. Remove the router from its protective bag.
Note:
Before installing the router, make sure that all modules are properly installed.
For information about the removal or installation of modules, refer to
Chapter 7
,
“
Hardware Module Replacement.
”
Caution:
Place the router onto a smooth surface away from any potential
exposure to direct sunlight, liquids or vapors, excessive heat, or risk of
accidental dropping or other damage.
2. Determine where the router will be mounted, ensuring that the air-flow vents
remain clear of obstructions.
3. Separate the inner rail from the outer-rail assemblies.
See
for an illustration.
a.
Place a thumb or finger over the circular grasping hole at the front-end of
the inner rail.
b.
Extend the inner rail out from the outer-rail assembly until it locks into
place.
c.
Press the spring-latch on the back-side of the inner rail to release the lock.
While holding down the spring-latch, extend the inner rail until the two
rails separate.
Summary of Contents for StorageWorks M2402
