HP StorageWorks M2402, User Manual

Page: 145 / 282

Serial/Telnet User Interface
127 Network Storage Router M2402 User Guide
■
Set Discovery Delay Time (4) sets the length of time the router waits after a
power-up or reboot before discovering SCSI devices.
Note: This value should be set to no less than 250ms, according to the SCSI standard
for Reset-to-Selection Time. HP recommends setting the value to at least 2 seconds to
ensure all SCSI devices complete their individual power on self tests (POST.)
■
Set SCSI Termination Mode (5) enables or disables the SCSI termination
mode.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
■
Set SCSI Target Override Settings (6) changes the SCSI Target overrides.
Caution: If these configuration settings are incorrectly set, processing
difficulties may occur. Before changing these settings, evaluate the need for the
change and verify the desired setting. HP recommends backing up the router
configuration to an external file before making changes to this setting.
SCSI Parameter Override Configuration Menu options:
— Toggle CDB Length Override (1)—enabled or disabled.
If enabled, the following configuration options are displayed:
CDB Group 6 Length Default (default = 0) can be set to 0, 6, 10, or 12.
CDB Group 7 Length Default (default = 0) can be set to 0, 6, 10, or 12.
— Toggle Wide Negotiation (2)—enabled or disabled.
— Toggle Synchronous Negotiation (3)—enabled or disabled.
If enabled, the following configuration options are displayed:
Synchronous Period (default = 40) the maximum number of seconds
allowed for negotiation.