Installing and Configuring the Director
52
Director 2/64 Installation Guide
Figure 13: Aligning the switch in the rack
3. Loosely attach the rear angle bracket to the rack rail with the two panhead
Phillips screws provided, as shown in
4. Repeat
step 2
and
step 3
for the corresponding rear angle bracket, as shown in
.
5. The two rear angle brackets now touch the outside surfaces of the rear
mounting plates. Slide the switch all the way into the rack to where the front
mounting bracket meets the rack rails.
6. If you are certain that the hardware lines up properly, secure the hardware as
follows:
a.
Secure each rear mounting plate to the rear angle bracket with the two
screws provided.
b.
Move to the front of the switch and secure each front mounting bracket
with the three screws provided.
