HP ProLiant ML100 Series, User Manual

Page: 63 / 103

Server cannot find the DLT drive
plicate SCSI IDs in use and refer to the
umentation of the DLT drive and the array controller to be sure they are compatible.
er has not been exceeded. Refer to the controller
ity of the controller.
s exist.
Action :
•
Be sure a device conflict does not exist. Check for du
doc
•
Be sure the maximum number of drives per controll
documentation to determine the capac
NOTE: It is recommended that no more than two DLT drives per bu
d to the unused SCSI IN
, be sure the SCSI terminator is connected.
DLT drives can be daisy chained, but do not connect more than three units per SCSI controller. The
DLT drive in the chain requires the SCSI terminator.
about the message. If the error does not disrupt
the backup, you may be able to ignore the error.
Fan problems
n
s panels
d replacing fans.
access panels, and then attempt to restart the server.
n.
perating the server for an extended period
of time with the access panel removed, airflow may have been impeded, causing thermal damage
mentation for further requirements.
sure no POST error messages are displayed while booting the server that indicate temperature
r documentation
ntation for requirements.
•
If using an external DLT drive that requires a SCSI terminator to be secure
connector on the back of the drive
last
•
Check cables for damaged or bent connectors.
An error occurs during backup, but the backup is completed
Action : Contact the software vendor for more information
Ge eral fan problems are occurring
Action :
1.
Be sure the fans are properly seated and working.
a.
Follow the procedures and warnings in the server documentation for removing the acces
and accessing an
b.
Unseat, and then reseat, each fan according to the proper procedures.
c.
Replace the
2.
Be sure the fan configuration meets the functional requirements of the server. Refer to the server
documentatio
3.
Be sure no ventilation problems exist. If you have been o
to components. Refer to the server docu
4.
Be
violation or fan failure information. Refer to the server documentation for the temperature
requirements for the server.
5.
Replace any required non-functioning fans and restart the server. Refer to the serve
for specifications on fan requirements.
6.
Be sure all fan slots have fans or blanks installed. Refer to the server docume
7.
Verify the fan airflow path is not blocked by cables or other material.
Troubleshooting 63