Removal and replacement procedures 46
4.
Remove the PPM.
IMPORTANT:
PPM slots must be populated when processors are installed. If PPM slots are not
populated, the server halts during POST or does not boot.
To replace the component, reverse the removal procedure.
PPM retainer
To remove the component:
1.
Power down the server (on page
30
).
2.
Extend the server from the rack (on page
29
).
3.
Remove the access panel ("
Access panel
" on page
32
).
4.
Remove the PPMs ("
PPM
" on page
45
).
Summary of Contents for ProLiant DL380 G5 DPSS
