6. For an SFF DVD drive, do the following:
a. Disconnect the SATA DVD cable from the system board to fully remove the DVD drive
from the bay by removing Torx screws (1) and then pulling out DVD drive (2). The Torx
service tool is located inside server next to the power supply housing.
b. Remove the DVD drive from the server.
Figure 3: Removing a DVD R/W drive
c. Disconnect the SATA DVD cable from the rear of the DVD drive.
7. Remove the bezel blank from the DVD - ROM bay (refer to appropriate users guide section).
To insert DVD drive:
8. For an SFF DVD drive, do the following:
a. Install the DVD drive using the screws from this kit and a T - 10/T - 15 Torx screwdriver.
b. Connect the cable to the rear of the drive and to the SATA DVD - ROM drive connector
on the system board.
c. Clip the cable to the power supply air baffle when routing it along the edge of the
system board.
9. Install the access panel
10. Slide the server into the rack.
11. Connect each power cord to the server.
Internal server components
September 2013
Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server
23
