Removal and replacement procedures
Maintenance and Service Guide
4–35
Power and RJ-45 cable
✎
The power and RJ-45 cables are included in the Cable Kit, spare part number 580843-001.
Before removing the power and RJ-45 cables, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
“Battery” on page 4-6
).
5. Remove the following components:
a. Hard drive (see
“Hard drive” on page 4-9
)
b. Memory module compartment cover (see
“WLAN module” on page 4-12
)
c. Keyboard (see
“Keyboard” on page 4-16
)
d. Display assembly (see
“Display assembly” on page 4-22
)
e. Top cover (see
“Top cover” on page 4-19
)
f. System board (see
“System board” on page 4-33
)
Remove the power and RJ-45 cables:
1. Release the power connector from the clip built into the system board
,
and then remove it
1
.
2. Release the RJ-45 connector from the clip built into the system board
,
and then remove it
2
.
Reverse this procedure to install the power and RJ-45 cable.
Summary of Contents for PAVILION DM3
