27
Tasks at a glance
Tuning and optimizing RIP networks
•
•
Enabling split horizon and poison reverse
•
Setting the maximum number of RIP ECMP routes
•
Enabling zero field check on incoming RIPv1 messages
•
Enabling source IP address check on incoming RIP updates
•
Configuring RIPv2 message authentication
•
Setting the RIP triggered update interval
•
•
Configuring RIP network management
•
Configuring the RIP packet sending rate
•
Setting the maximum length of RIP packets
•
Setting the DSCP value for outgoing RIP packets
Configuring basic RIP
Before you configure basic RIP settings, complete the following tasks:
•
Configure the link layer protocol.
•
Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
Enabling RIP
Follow these guidelines when you enable RIP:
•
To enable multiple RIP processes on a router, you must specify an ID for each process. A RIP
process ID has only local significance. Two RIP routers having different process IDs can also
exchange RIP packets.
•
If you configure RIP settings in interface view before enabling RIP, the settings do not take
effect until RIP is enabled.
•
If a physical interface is attached to multiple networks, you cannot advertise these networks in
different RIP processes.
•
You cannot enable multiple RIP processes on a physical interface.
•
The
rip enable
command takes precedence over the
network
command.
Enabling RIP on a network
You can enable RIP on a network and specify a wildcard mask for the network. After that, only the
interface attached to the network runs RIP.
To enable RIP on a network:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
