36
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type interface-number
N/A
3.
Configure RIPv2
authentication.
rip authentication-mode
{
md5
{
rfc2082
{
cipher
|
plain
}
string
key-id
|
rfc2453
{
cipher
|
plain
}
string
} |
simple
{
cipher
|
plain
}
string
}
By default, RIPv2
authentication is not
configured.
Setting the RIP triggered update interval
Perform this task to avoid network overhead and reduce system resource consumption caused by
frequent RIP triggered updates.
You can use the
timer triggered
command to set the maximum interval, minimum interval, and
incremental interval for sending RIP triggered updates.
•
For a stable network, the
minimum-interval
is used.
•
If network changes become frequent, the incremental interval
incremental-interval
is used to
extend the triggered update sending interval until the
maximum-interval
is reached.
To set the triggered update interval:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIP view.
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Set the RIP triggered
update interval.
timer triggered maximum-interval
[
minimum-interval
[
incremental-interval
] ]
By default:
•
The maximum interval
is 5 seconds.
•
The minimum interval is
50 milliseconds.
•
The incremental interval
is 200 milliseconds.
Specifying a RIP neighbor
Typically RIP messages are sent in broadcast or multicast. To enable RIP on a link that does not
support broadcast or multicast, you must manually specify RIP neighbors.
Follow these guidelines when you specify a RIP neighbor:
•
Do not use the
peer ip-address
command when the neighbor is directly connected. Otherwise,
the neighbor might receive both unicast and multicast (or broadcast) messages of the same
routing information.
•
If the specified neighbor is not directly connected, disable source address check on incoming
updates.
To specify a RIP neighbor:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIP view.
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
