37
Step
Command
Remarks
3.
Specify a RIP neighbor.
peer
ip-address
By default, RIP does not
unicast updates to any
peer.
4.
Disable source IP
address check on
inbound RIP updates
undo validate-source-address
By default, source IP
address check on inbound
RIP updates is enabled.
Configuring RIP network management
You can use network management software to manage the RIP process to which MIB is bound.
To configure RIP network management:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Bind MIB to a RIP
process.
rip mib-binding
process-id
By default, MIB is bound to the
RIP process with the smallest
process ID.
Configuring the RIP packet sending rate
Perform this task to set the interval for sending RIP packets and the maximum number of RIP
packets that can be sent at each interval. This feature can avoid excessive RIP packets from
affecting system performance and consuming too much bandwidth.
To configure the RIP packet sending rate:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIP view.
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Set the interval for sending
RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.
output-delay time
count
count
By default, an interface sends up
to three RIP packets every 20
milliseconds.
4.
Return to system view.
quit
N/A
5.
Enter interface view.
interface
interface-type
interface-number
N/A
6.
Set the interval for sending
RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.
rip output-delay time
count
count
By default, the interface uses the
RIP packet sending rate
configured for the RIP process
that the interface runs.
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
