Hood sensor
The hood sensor is attached to the rear of the chassis.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 18
).
2.
Remove the access panel (
Access panel on page 19
).
3.
Rotate the small baffle into the upright position (
Small baffle on page 48
).
4.
Disconnect the hood sensor cable from the system board connector labeled HSENSE.
5.
Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be
required to disengage the hood sensor from the slot.
To install the hood sensor, reverse the removal procedure.
52
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
Summary of Contents for EliteDesk 800 G2 Desktop Mini
Page 1: ...Maintenance and Service Guide HP EliteDesk 800 G2 SFF Business PC ...
Page 4: ...iv Safety warning notice ...
Page 10: ...x ...
Page 61: ...Hood lock 51 ...