Front I/O Device
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 83
).
2.
Remove the access panel (
Access Panel on page 84
).
3.
Remove the front bezel (
Front Bezel on page 85
).
4.
Rotate the drive cage to its upright position.
5.
Unplug the audio cable from the yellow system board connector labeled F_AUDIO.
6.
Unplug the USB cable from the white system board connector labeled F_USB1.
7.
Rotate the drive cage back down.
8.
Remove the screw that secures the front I/O device to the chassis
(1)
.
9.
Rotate the assembly toward the right side of the chassis
(2)
, and then slide the device slightly
toward the left
(3)
to disengage the tab on the right side of the assembly from the chassis. Thread
the wires through the hole in the chassis and remove the assembly.
NOTE:
If necessary, rotate the drive cage back up to better access the hole you thread the cables
through.
To install the front I/O device, reverse the removal procedures.
114 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
