![background image](http://html.mh-extra.com/html/hp/bladesystem-c7000/bladesystem-c7000_maintenance-and-service-manual_156957049.webp)
Removal and replacement procedures 49
15.
Remove the two slotted T-15 Torx screws that secure the interconnect board.
16.
Remove the interconnect board.
To replace the component, reverse the removal procedure.
Insight Display signal pass-thru board
WARNING:
To reduce the risk of damage to the midplane and component connectors, always
remove or disengage and extend all blades and power supplies approximately 8 cm (3 in) before
removing or installing the rear cage.
To remove the component:
1.
Power down the server blades ("
Power down the server blades or workstation blades
" on page
28
).
2.
Power down the enclosure (on page
29
).
3.
Disconnect all cables.