The default read community name is “public,” and the default write community name is blank.
Modifying the System Location
NOTE:
The SNMP protocol can be disabled in the Network Configuration area of the Web-based user
interface.
To modify the system location information using the Web-based user interface:
1.
Click the
Enclosure
tab.
2.
Click
SNMP Configuration
in the left panel.
3.
Set the cursor in the
System Location
field and type the appropriate information.
4.
Click
Apply
.
To modify the system location information using the CLI, type:
SET SNMP LOCATION <location>
The <location> field must be 1-20 characters long and supports all the alphanumeric characters, the
underscore, the dash, and spaces with quotes.
Modifying the System Contact Information
To modify the system contact information using the Web-based user interface:
1.
Click the
Enclosure
tab.
2.
Click
SNMP Configuration
in the left panel.
3.
Set the cursor in the System Contact field and type the appropriate information.
4.
Click
Apply
.
To modify the system contact information using the CLI, type:
SET SNMP CONTACT <contact>
The <contact> field must be 1-20 characters long and supports all the alphanumeric characters, the
underscore, the dash, and spaces with quotes.
Adding Trap Targets
To add a trap target using the Web-based user interface:
1.
Click the
Enclosure
tab.
2.
Click
SNMP Configuration
in the left panel.
3.
Type the IP address in the appropriate field of the SNMP area.
4.
Click
Add
.
5.
Click
Apply
.
To add a trap target using the CLI, type:
ADD SNMP TRAPRECEIVER <IP address>
86
Chapter 6 Setting Up the System
ENWW
