Switch cover
Description
Spare part number
Switch cover (includes LED board and cable)
450479-001
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 46
).
5.
Remove the keyboard (see
Keyboard on page 62
).
Remove the switch cover:
1.
Turn the computer upside down, with the rear panel toward you.
2.
Remove the four Torx T8M2.5×4.0 screws that secure the switch cover to the computer.
3.
Turn the computer right-side up, with the front toward you.
4.
Open the computer as far as possible.
5.
Disconnect the power button board cable
(1)
from the system board.
Component replacement procedures
69
Summary of Contents for 8710w - HP Mobile Workstation
